Pool and Spa Combination Layout Guide
A spa attached to a pool isn't just a smaller, hotter section of the same water, it's a separate plumbing and heating zone layered into one design. This site is dedicated to a single build method: gunite (shotcrete) construction, rebar cage, sprayed and hand-finished concrete, engineered bond beams, and a design that can be shaped to anything the lot allows, from tanning ledges to negative edges to integrated spas.
Raised Spillover vs. In-Line
A raised spillover spa sits above the pool deck level with water spilling over its wall into the pool, giving a visual and sound feature in addition to a separate soaking space. An in-line spa sits at pool level, separated by a low wall or nothing at all, simpler and less expensive to build but without the spillover visual.
Separate Heating, Shared Pump (Usually)
A spa needs to heat and circulate independently from the main pool (so it can run hot without heating the whole pool), which usually means a separate heater zone and valve-controlled plumbing even when both share the same pump, a detail that gets engineered during design, not improvised later.
Where This Fits
See our Gunite Pools service page, or Financing if cost is the next question.
Related Reading
Small-Yard Pool Design Ideas
How to get a real pool, not a compromise, out of a tight suburban lot.
Pool Decking Materials Compared
Stamped concrete, pavers, travertine, and wood-look composite: how they compare for heat, cost, and upkeep.
Pool Tile and Coping Materials Guide
Waterline tile and coping choices, and what actually holds up around Houston-area pool water and sun exposure.
Get a Free Quote
Tell us about your project and we’ll follow up within one business day.